What are the common problems and solutions of embroidery machines?

Embroidery machine is a modern intelligent machine, mainly used in clothing and shoes and hats. Despite its powerful function, there will be some common failures in the process of use, which will affect the efficiency and quality of the work once they occur. In order to better use and maintain the embroidery machine, the following are the common problems and solutions of the embroidery machine. 1. Embroidery thread break problem analysis: thread break is one of the most common faults in the operation of embroidery machine. This is usually caused by a thread that is not properly threaded through the thread holder, needle, or needle plate. Solution: First, check whether the wire tip is passing through the wire. If not, pass it through the wire carrier correctly. Secondly, confirm whether the thread end passes smoothly through the machine needle. If it does not pass, try removing the needle and then reinstalling it. Finally, determine whether the needle board is causing the problem. If this is the problem, the needle board can be removed, wiped off the residue on it or replaced with a new needle board. 2. Analysis of uneven sewing problem: When stitching, if the sewing line of the embroidery machine has a wavy line or is too tight or too loose, it will lead to uneven sewing. Solution: First of all, check whether the stitches are correctly passed through all the steps of the machine, including the equipment of the spool, thread holder, needle, needle plate, and downloader. If everything is normal, you can try to adjust the tension of the downline, or replace the needle board or replace it with a wire of the same quality, in order to make the sewing more smooth. 3. Analysis of thread problems after sewing: When the sewing is finished and the embroidery machine leaves the original position, some thread is often left. Solution: Dealing with thread is very simple, just need to leave more thread when making clothes, you can also use scissors to trim off the thread directly after sewing. If you have finished sewing and find that there are still some threads,